DynoJet Dual Tune on a KTM SDGT

Post Reply
GaryCulb
500cc
500cc
Posts: 130
Joined: Thu Aug 17, 2017 11:19 am
Country: USA
City: Sumter
Year: 2017
Location: Sumter, SC
Contact:

DynoJet Dual Tune on a KTM SDGT

Post by GaryCulb » Thu Sep 06, 2018 12:26 am

Looking for anyone that has installed the DynoJet Dual Tune on a KTM SDGT?? Specifically, want to know & see where you or your vendor installed the 18 mm O2 bungs on the exhaust. Local KTM dealer has been off little assistance. Cannot get any pictures from Rottweiler but, they say the 18 mm O2 bungs will go where the old 12mm O2 bungs are located. Without some significant move they will not fit. The DynoJet Dual Tune O2 sensors require 5 inches of clearance in length. Rear manifold on the KTM SDGT is covered with a OEM Factory insulation to reduce heat. Do they just take that off??

So, where does one install the DynoJet Dual Tune 18 mm O2 bungs on a 2017 KTM SDGT??

Best,

Doc :? :?

Post Reply